Through our partnership with Leister, COMANCO hosted an intensive training session on the Leister GEOSTAR G7 wedge welders. Worldwide Repair & Service Engineer Daniel Barmet traveled from Leister’s Switzerland office to share his wealth of knowledge of the units with our Fleet technicians, while Field Sales Engineer Paul Maniscalco worked with associates from our Operations Divison. It is rare to find manufacturers who are willing to share such in-depth knowledge as Leister does. This type of customer service provides great value, especially since COMANCO services our own equipment. The COMANCO Fleet department’s expectation is that it meets or exceeds “like new” performance when it goes to a job site.
Technician Training Included:
- Mechanical troubleshooting & disassembly
- Electrical troubleshooting, testing & repair (down to board level)
- Drive unit, track roller, wedge suspension, swivel-head, etc.
- Wedge replacement & care
- Adjustment, change, and calibration of force sensor
- Heating cartridges, thermocouples, fan, etc.
- Earth conductor, insulation, function test, etc.
Operational Training Included:
- Initial setup & adjustment
- Parameter adjustment for different liners
- Digital force control set-up
- Field troubleshooting
- Machine optimization
- Data acquisition of speed, time, temp., pressure, etc.
- Error codes
COMANCO Fleet would like to extend a special ‘thank you’ to:
Daniel Barmet: Worldwide Repair & Service Engineer – Responsible for repair training.
Paul Maniscalco: Field Sales Engineer – Responsible for G7 field operation training.
SAFETY ★ QUALITY ★ SERVICE
